This is a guide to install the software (CCAutoServer and CCAutoClient)and a basic configuration which after this step-by-step instruction a terminal (with IP 192.168.1.1) will be connected to server (with IP 192.168.1.100), and you will be able to control the terminal.

After download the CCAutoSoft installation file (normally in single zip file), unzip(extract) the file into a directory.

Warning! Do not run the installation process from within WinZip application. Extract the zip file in a folder first and close WinZip.

CCAutoServer setup
CCAutoServer should be installed in a normal PC in your cyber cafe's counter.

1. Go to the folder where you extract the file, find in setup.exe and double-click. If the you are asked to restart the PC, restart it first and then go to step 1 again.
2. Setup window will be shown, read the license aggreement. Click next.
3. Select CCAutoServer. Click next.
4. Wait until the installation finish usually in less than a minute.
5. Restart your PC.

Basic configuration for CCAutoServer

1. Start CCAutoServer.
2. Login : select Admin, Password: admin, click Enter button.

When asked to "Enter Safe Mode", click "No".


3. CCAutoServer's main window will appear.


4. Click Setting from the Side Panel and press Terminal.

Terminal Setting's window will appear.


5. Remove any listed terminal.

6. Insert terminal name (just create any name, e.g:PC 01). Insert the terminal's IP address (to find the IP address, go to a terminal(PC01) > right-click on Network Neighborhood > Tcp/Ip > properties > IP address, e.g: 192.168.1.101)

7. Press Add button. Close the window and restart CCAutoServer.



CCAutoClient
Install in PC which you want to control. (e.g: PC01 with IP address 192.168.101 which you have inserted the data in CCAutoServer in above steps.)

1. Go to the folder where you extract the file, find setup.exe and double-click. If the you are asked to restart the PC, restart it first and then go to step 1 again.
2. Setup window will be shown, read the license aggreement. Click next.
3. Select CCAutoClient. Click next.
4. Wait until the installation finish usually in less than a minute.
5. Restart your PC.

Basic configuration for CCAutoClient
Default, when the terminal is connected to CCAutoServer, the terminal desktop will be locked. If it is not connected, it will be unlocked with a small CCAutoClient window at the low right of desktop. We assume, there is no problem, so the terminal is connected and locked.

1. Insert "admin" password in the box on the locked desktop. The destop will be unlocked.

2. On CCAutoClient press Setting

3. Password window appear, insert admin password : admin

4. ClientSetting window will appear, find Server's IP Address box in Configuration tab and insert your server's IP Address e.g: 192.168.1.100 .(The server is which PC you installed with CCAutoServer.)

5. Click Save and Close. Choose restart CCAutoClient if asked.

The terminal is now connected to CCAutoServer.

Favourite links :
1. The Need for Hard Disk Image Backup For Internet Cafe
2. Connecting All Hardwares in Internet Cafe
3. Basic Internet Cafe Requirement: Hardware and Software
4. Help & Troubleshooting